How to connect an USB port on the Arduino Industrial 101

In this tutoria is shonw how to connect an USB port on the Arduino Industrial 101.

The standard USB port type A is formed by four pins, as shown in the below image:

Standard USB port

These pins are reported also in the back side of the port. Connect these pins as suggested in the below table

USB Arduino Industrial 101
 -  GND
D+ D+
D- D-
+ 5V

So the USB port should work.

Now, plug a device or a pen drive, enter to the linino console and veriry if the port is available, using the command:
df -h

df -h command

The new peripheral should be shown.
If you want to mount it then use this command:
cd /mnt/sda1/ 
Instead to umount use this other command:
umount /dev/sda1