The board supports this connection type but you need of an Ethernet connector female, for example the Rj45/RB1 125BHQ1A.
Connect the RJ45 female connector to the board following the below table:
|Connector Rj45 Female ||Arduino Industrial 101 |
|R1 ||TD+ |
|R2 ||TD- |
|R3 ||2V |
|R4 ||RD+ |
|R5 ||RD- |
|R6 ||GND |
|R7 ||NC |
|R8 ||NC |
|R9 ||NC |
|R10 ||NC |
Plug the Lan cable on the RJ45 connector and connect the board to PC, wait some seconds.
When the Lan connection will be active the Wlan Led will turn on.
the Lan cable is formed of 8 wires as shown in the below image: